Precharge to Active Trp This items allows you to specify the delay from precharge command to activate command. This connector allows user to connect pin power connector on the ATX power supply. PC Health Status This submenu allows you to monitor the hardware of your system. System A password is required for the system to boot and is also required to access the Setup Utility. AGP1 Your monitor will attach directly to that video card.

Uploader: Yozuru
Date Added: 20 February 2006
File Size: 29.37 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 20166
Price: Free* [*Free Regsitration Required]

However, any programs writing to this area of memory will cause conflicts and result in system errors.

Biostar M7VIZ – 8.X – motherboard – micro ATX – Socket A – KM400

With a user-friendly Status Animation, it can represent 3 overclock percentage stages: O ve rclock Panel contains the these features: Soif the AGP driver of the VGA card does not support the initialization featurethe display may work abnormally or not function after S3. This connector supports the provided floppy drive ribbon cables. In this panel, you can decide to increase CPU core voltage and Memory voltage or not.

When you see the following dialog in setup procedure, it means setup is completed. Enabled default Optional ROM is enabled. Each category includes no, one or more than one setup items. Load Optimized Defaults This selection allows you to reload the BIOS when the system is having problems particularly with the boot sequence. Delay 4 Sec, Instant-Off default. It will disable the output on back panel audio connectors.


You will be prompted with to enter a password. In this case, please double check: If the signal has been triggered, it will record aaudio the CMOS and show the message on next boot-up.

Biostar M7VIZ-SATA Owner’s Manual

Disabled defaultenable. The BIOS has been recovered and will work properly.

However, if any program writes to this memory area, a system error may result. DDR memory Riser slot.

This section covers some very technical items and it is strongly recommended that only experienced users should make any changes to the default settings. This item only effective under ACPI mode.

Power header f or system f an. Every peripheral device has a node, which is called ESCD. Blank Screen This option only writes blanks to the video buffer. Setup default A password is required to access the Setup Utility only. Maximum memory size is audik.

Biostar M7VIZ – 8.X – motherboard – micro ATX – Socket A – KM Overview – CNET

Pull the lever sideways away from the socket and then raise the lever up to a degree angle. The Main Menu allows you to select from several setup functions. Off defaultOn. Disabled default15M — 16M. The default settings that came with your system have been optimized and therefore should not be changed unless you are suspicious that the settings have been changed incorrectly.


IRQ Resources This submenu will allow you to assign each system interrupt a type, depending on the type of device aurio the interrupt. Drive A K, 5. akdio

User Define default Allows you to set each mode individually. Execute the setup execution file, and then the following dialog will pop up. After confirmed, please follow steps below to relief the CPU protection function.