GESTETNER DSC38 PRINTER DRIVER DOWNLOAD

With this machine refer to the inch version. The recommended or minimum space requirements are as follows: Setting Up Keep pressing the Memory Unit down until it clicks into the locked position. Hook the External Tray to the slits of the printer, and then lower the tray toward you. Install the Finisher on the left side of the printer. Close Tray 1 slowly.

Uploader: Maujinn
Date Added: 13 March 2018
File Size: 46.80 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 98947
Price: Free* [*Free Regsitration Required]

Temporarily fasten one long screw in the position shown in the illustration. Close Tray 1 slowly. A Stand it vertically. Prinnter that the power switch is c Stand by”.

Gestetner DSc38 Setup Manual

Toner dust is flammable and might ignite getsetner exposed to an open flame. When “Replace Waste Toner Type E ” appears on the panel display, replace with a new waste toner bottle. Hook the External Tray to the slits of the printer, and then lower the tray toward you.

Tray 2 standardsheet Paper Feed Unit, sheet Paper Feed Unit Align all four sides of the paper stack, and then load it in the tray. Setting Up Where to Put gestetnrr Printer The printer’s location should be carefully chosen because environmental condi- tions greatly affect its performance. Parallel Connection Setting Up Parallel Connection Use an interface cable to connect the printer to the host computer with a parallel connection.

New Drivers  MARVELL 88E8040 XP DRIVER DOWNLOAD

Open the right cover of the sheet Large Capacity Tray.

Page 48 Printer Hard Disk is shown on the panel display. Install the External Tray to the printer. Page 40 Setting Up Remove two screws that are fas- tening the Controller Board on the back of the printer using pro- vided screwdriver.

Page 34 Setting Up Hook the mounting bracket to the hole as shown in the illustration. The recommended or minimum space requirements are as follows: Setting Up Keep pressing the Memory Unit down until it clicks into the locked position.

Gestetner Dscu Color | Dsc :: Dsc38 :: 38 – Detailed Printer Specifications

Installing the Duplex Feed Unit Open the front cover slowly by pulling the two points on the left and right. Slide Tray 2 back into the printer slowly until gestetne stops.

Page 33 Fasten one thumb screw. Hook the mounting bracket to the hole as shown in the illustration. A message indicating that you have completed formatting is shown on the panel display.

Page 63 Holding both sides of the 4-bin Mailbox with both hands, stand on the left side of the printer. Setting Up Fasten one thumb screw. Fasten the rails with a long screw using provided screwdriver.

New Drivers  845GV NETWORK DRIVER

Insert the rail with a wheel in the egstetner bracket. Insert the hooks of the Ex- ternal Tray into the printer slits, and then lower it toward you. Installing the User Account If you do not load paper, the setup procedure will not complete properly. Install the 4-bin Mailbox. Page 71 Release the lock of the side guide.

Gestetner DSC Series

Ethernet Port Use an network interface cable to connect the printer to the network. Fasten the bracket with the other thumb screw. Stick label “3” above the handle on the front of the sheet Paper Feed Unit.

Indicates a potentially hazardous situation which, if instructions are not followed, could result in death or serious injury. To exit Low-power Energy Saver mode, press any key on the operation panel. Page of 82 Pinter.